TM 5-3805-293-23-1
0014
Table 1. All-Wheel Drive (AWD) Code Troubleshooting - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2296-05 Left Front Drive
7. Check for Active code 2296-05 or
Code 2296-05 Remains Active - Pro-
Pump Reverse Control Sole-
2296-06 in All Wheel Drive 120M
ceed to Test Step 5.
noid Current Below Normal -
ECM (WP 0006).
Code 2296-05 Becomes Inactive
Continued
and 2296-06 Becomes Active -
Remove jumper wire from P-C69 ter-
minal 70 (WP 0009, Figure 46) and P-
C71 terminal 12 (WP 0009, Figure
18).
Replace rear chassis wiring harness
(WP 0188).
Connect AX-C1 (WP 0009, Figure
100) on AC-C1 (WP 0009, Figure
101).
Connect AX-C3 (WP 0009, Figure
104) on left drive pump reverse sole-
noid connector (WP 0009, Figure 105)
and close access door.
Install front engine enclosure access
panel (WP 0226).
Proceed to step 8.
8. Using the MSD (WP 0006), select
2296-05 Code Active - Repeat trou-
All Wheel Drive 120M and verify
bleshooting code from the beginning.
2296-05 is not active.
2296-05 Code Not Active - Trouble-
shooting complete.
Test Step 5. Test Left Front Drive
Pump Reverse Control Solenoid
Circuit for High Resistance or Open
in Cab Lower Wiring Harness.
1. Turn ignition switch and battery
disconnect switch to the OFF
position.
2. Remove jumper wire from P-C69
terminal 70 (WP 0009, Figure 46)
and P-C71 terminal 12 (WP 0009,
Figure 18).
3. Disconnect cab lower wiring P-
C35 harness connector (WP
0009, Figure 53) from AWD ECM
J1 (WP 0009, Figure 54) (WP
0270).
0014-59