TM 5-3805-293-23-1
0013
Table 1. All-Wheel Drive (AWD) Code Troubleshooting - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0041-04 8 Volt DC Supply
1. Connect MSD (WP 0006). Select
Voltage Below Normal -Con-
All Wheel Drive 120M and verify
tinued
0041-04 is active.
2. Turn ignition switch and battery
disconnect switch to the OFF
position.
3. Remove rear front frame cover
from machine (WP 0224).
4. Disconnect clutch drive solenoid
AF-C3 harness connector (WP
0009, Figure 51) from cab lower
wiring P-C34 harness connector
(WP 0009, Figure 52) (WP 0200).
5. Turn battery disconnect switch
and ignition switch to the ON posi-
tion.
6. Check for Active code 0041-04 in
Code 0041-04 Remains Active - Pro-
All Wheel Drive 120M ECM (WP
ceed to Test Step 2.
Code 0041-04 Becomes Inactive -
Proceed to Test Step 5.
Test Step 2. Test 8-Volt Supply Cir-
cuit for Short to Other AWD Cir-
cuits in Cab Lower Wiring Harness.
1. Turn ignition switch and battery
disconnect switch to the OFF
position.
2. Disconnect cab lower wiring P-
C35 harness connector (WP
0009, Figure 53) from AWD ECM
J1 (WP 0009, Figure 54) (WP
0270).
3. Disconnect cab lower wiring P-
C37 harness connector (WP
0009, Figure 55) from AWD ECM
J2 (WP 0009, Figure 56) (WP
0270).
4. Using a digital multimeter, test for
No Continuity - Proceed to step 5.
continuity between P-C35 termi-
Continuity - Replace cab lower wiring
nal 44 and all other circuits in P-
harness (WP 0266).
C35 (WP 0009, Figure 53), and
Install rear front frame cover on
ground. There should be no conti-
machine (WP 0224).
nuity.
Proceed to step 6.
0013-5