TM 5-3805-293-23-1
0013
Table 1. All-Wheel Drive (AWD) Code Troubleshooting - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
Test Step 2. Test 8-Volt Supply Cir-
0041-03 8 Volt DC Supply
cuit for Short to Other Circuits in
Voltage Above Normal -
Cab Lower Wiring Harness.
Continued
1. Turn ignition switch and battery
disconnect switch to the OFF
position.
2. Disconnect cab lower wiring P-
C35 harness connector (WP
0009, Figure 53) from AWD ECM
J1 (WP 0009, Figure 54) (WP
0270).
3. Disconnect cab lower wiring P-
C37 harness connector (WP
0009, Figure 55) from AWD ECM
J2 (WP 0009, Figure 56) (WP
0270).
4. Using a digital multimeter, test for
No Continuity on Any Test Points -
continuity between P-C35 termi-
Proceed to step 6.
nal 44 and all other circuits in P-
Continuity on One or More Test
C35 (WP 0009, Figure 53). There
Points - Replace cab lower wiring
should be no continuity.
harness (WP 0266).
Install rear front frame cover on
machine (WP 0224).
Proceed to step 5
5. Using the MSD (WP 0006), select
0041-03 Code Active - Repeat trou-
All Wheel Drive 120M and verify
bleshooting code from the beginning.
0041-03 is not active.
0041-03 Code Not Active - Trouble-
shooting complete.
6. Using a digital multimeter, test for
No Continuity on Any Test Points -
continuity between P-C35 termi-
Proceed to Test Step 3.
nal 44 (WP 0009, Figure 53) and
Continuity on One or More Test
all circuits in P-C37 (WP 0009,
Points - Replace cab lower wiring
Figure 55). There should be no
harness (WP 0266).
continuity.
Install rear front frame cover on
machine (WP 0224).
Proceed to step 7
7. Using the MSD (WP 0006), select
0041-03 Code Active - Repeat trou-
All Wheel Drive 120M and verify
bleshooting code from the beginning.
0041-03 is not active.
0041-03 Code Not Active - Trouble-
shooting complete.
0013-3