TM 5-3805-293-23-1
0011
Table 2. Engine Troubleshooting with Codes for the 120M Motor Grader - Continued.
CDI FMI CODE
ERROR/EVENT
CORRECTIVE ACTION
0100-03 Engine Oil Pres-
System Response:
sure Sensor Voltage Above
ECM will log diagnostic code. A warn-
Normal
ing will appear on instrument panel.
ECM will set data for engine oil pres-
sure to default value.
Possible Performance Effect:
None.
N OT E
The 5-Volt supply circuit is a common supply circuit which is bussed
internally of the Engine ECM. The supply voltage is 5.0 0.16 Volts.
Out put of the 5-Volt supply circuit is at Engine ECM J2-46 circuit T997-
OR, J2-47 circuit L730-OR, J2-48 circuit R997-OR, and J1-42 circuit
R997-OR. The 5-Volt supply circuits are supplied to the intake manifold
pressure sensor terminal 1, the engine oil pressure sensor terminal 1,
the fuel rail pressure sensor terminal 1, and the turbocharger air inlet
pressure sensor terminal A.
Each sensor has a return or ground circuit and is a common supply
circuit which is bussed internally of the Engine ECM. The sensor return
circuit is at Engine ECM J2-40 circuit Y940-BR, J2-39 circuit Y947-BR,
J2-38 circuit T993-BR, and J1-34 circuit R993-BR.
The engine oil pressure sensor signa circuit is an input to the Engine
l
ECM at Engine ECM J2-46 circuit 994-GY.
Test Step 1. Test Signal Circuit.
N OT E
Always inspect the harness connectorsthat are involved in the circuit.
Poor connections can often be the cause of a problem in an electrical
circuit. Verify that all connections in the circuit are clean and secure,
and that all connections are in good condition. If a problem with a
connection is found, correct the problem and verify that this diagnostic
code is active before performing this procedure.
Perform open or short circuit test ateach harness connection to identify
correct harness to replace.
Perform this test only if condition is active.
Engine ECM C6.6 120M and ver-
ify 0100-03 is active.
2. Turn ignition switch to the OFF
position.
3. Disconnect the engine oil pres-
Figure 19) harness connector.
0011-78