POWER TRAINSPECIFICATIONSTM 5-3805-263-14&P-2FINAL DRIVE8D4030(1) Torque for nuts . . . . . . . . . . . 300' ± 15 lb. ft. (408 ± 20 N•m)Bearing Adjsutment:Torque for studs . . . . . . . . . 110 + 15 lb. ft. (150 ± 20 N•m)Tools Needed: Spanner Wrench(2) Torque for nuts . . . . . . . . . . . . . .270 ± 11 lb. ft. (367 ± 15 N•m)(3) Torque for bolts.. . . . . . . . . . . . 270 ± 11 lb. ft. (367 ± 15 N•m)(4) Apply 5P960 Multipurpose Type Grease on these surfaces.NOTE: The procedure that follows must be used to put the correctamount of preload on the bearings for the final drive:1. Tighten nut (8) to a torque of 150 lb. ft. (205 N•m) withspanner wrench.(5) Adjust shim pack thickness to provide end play betweenhousings of ....000 to .002 in. (0.00 to 0.06 mm)(6) Install retainer with bevel toward sprocket as shown2. Turn sprocket (7) to put the bearings in their seats.3. Hit the hub of sprocket (7) with a large punch and a hammer.4. Repeat Steps 1, 2 and 3 until nut (8) does not turn when itis tightened.5. Loosen nut (8).6. Tighten nut (8) to a torque of 100 lb. ft. (135 N•m)7. If nut (5) is in a locking position, install the axle, retainer (9)and bolts.8. If nut (8) is not in a locking position, tighten the nut to thenext nearest locking position. Install the axle, retainer (8)and the bolts.2-135
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
