POWER TRAIN
TM 5-3805-263-14&P-2
DISASSEMBLY AND ASSEMBLY
TRANSMISSION
26. Remove retaining ring (40) with a screw-
driver.
27. Remove hub (39) from the shaft.
28. Install two 3/8”-16 NC forged eyebolts (43)
in carrier (44). Remove the carrier. Remove
the eyebolts.
29. Remove retaining ring (41) with a screw-
driver. Remove bearing (42) from the car-
rier.
30. Move pin (46) into shaft (45) with a punch
and a hammer. Remove shaft (45) from the
carrier.
31. Remove gear (48) and thrust washers (47).
Remove the bearing from the gear.
32. Repeat Steps 30 and 31 for the other gears.
Remove the pins from the shafts.
33. Remove housing (50). Remove the inserts
from the housing.
34. Remove springs (51). Remove ring gear
(49).
35. Remove the four discs and the three plates.
These plates and discs are for the No.6
clutch.
2-92
