ENGINE
DISASSEMBLY AND ASSEMBLY
TM 5-3805-263-148S2
ROCKER SHAFT
ASSEMBLE ROCKER SHAFT
1. Install rocker arms (5). brackets (I), washers
(4) and springs (2) on the rocker shaft.
2. Install rear support bracket (6) on rocker
shaft. Make sure hole in rear support bracket
is in alignment with hole in rocker shaft.
3. Put pin (3) in position in the bracket.
4. Install pin (3) through bracket and shaft with
a hammer.
5. Pin (3) must extend 9.60 mm (.378 in.) above
the bracket.
6. Install O-ring seal (7) in the rear support
bracket. Install rocker arm (8), the original
number of washers, spring, washer and retainer
ring on the rocker shaft.
7. Install the front support, rocker arm, original
number of washers, spring, washer and retainer
ring on the rocker shaft.
8. Install the plugs in each end of the rocker shaft
if they were removed.
end by:
a) install rocker shaft and push rods
1-169
