ENGINEDISASSEMBLY AND ASSEMBLYTM 5-3805-263-14&P-2FUEL INJECTION PUMP HOUSING AND GOVERNORINSTALL FUEL INJECTION PUMP HOUSINGAND GOVERNOR1. Put O-ring seals (1) and (2) in position on thefuel injection pump housing and governor. Putclean oil on the O-ring seals.2. Put the fuel injection pump housing and gover-nor in position on the oil manifold and thetiming gear plate with bolts (3) and nuts (4).3. Put drain line (5) into position on the clip on theengine block.CAUTIONAfter the fuel injection pump housing and gov-ernor are installed on the timing gear plate, besure the rack is tree to move. The O-ring seal(1) on the drive end of the fuel injection pumpcan hold the rack and prevent free movementof the rack. If the rack does not move freely,remove the fuel injection pump housing andgovernor and check the O-ring seal on the driveend of the fuel injection pump housing.4. Install heat shield (8) between the manifoldand fuel injection pump housing and governor.Tighten the bolt to a torque of 23 ± 4 N•m ( 17± 3 lb.ft.).5. Connect tube assemblies (6) and hose assembly(7) as shown.6. Install bolt (9) that holds the clip.7. Install tube assemblies (10) and (11) to theengine and the clip that holds them together.1-134
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
