TM 5-3805-263-14&P-1Operating TechniquesNOTE: The wheels normally should be near the verticalposition.11. Lean the wheels toward the slope for a heavier cut.12.Lean the wheels away from the slope for a lightercut.Keep the material from the slope moved to the outside ofthe rear wheels.The procedure shown is for the right side.Position the moldboard opposite to that shown for the leftside.Extreme Side ReachBe sure to ground the moldboard before retractingthe centershift lock pin.1.Move the centershift lock pin to the position shown.Move the centershift lever lock pin lever to the INDEXand RUN position.2.Sideshift the moldboard as shown.81
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
