High Bank Cuts - Right Side

TM-5-3805-263-14P-1 Grader Heavy Road Motorized Diesel Engine Driven Type I (Nonsectionalized) Type II (Sectionalized) Manual
Page Navigation
77

TM 5-3805-263-14&P-1 Operating Techniques High Bank Cuts - Right Side Be sure to ground the moldboard before retracting the centershift lock pin. 1. The road bed at the base of the cut must be uniform. 2. If the material is hard, slope the road bed slightly into the bank to keep the machine from sliding away from the bank. 3. Tip the moldboard 3/4 to full position forward. 4. Move the centershift lock pin to the position shown. Move the centershift lever lock pin lever to the INDEX and RUN position 5. Sideshift the moldboard to the right 6. Rotate the circle counterclockwise Lower the left lift cylinder while the circle is turning. 79

Privacy Statement
Press Release
Contact