Flat Bottom Ditching - TM-5-3805-263-14P-1

Operating Techniques - TM-5-3805-263-14P-1_73

Flat Bottom Ditching cont. - TM-5-3805-263-14P-1_75

TM-5-3805-263-14P-1 Grader Heavy Road Motorized Diesel Engine Driven Type I (Nonsectionalized) Type II (Sectionalized) Manual
Page Navigation
70

TM 5-3805-263-14&P-1 12. Finishing shoulder pass. 13. Level and finish. Flat Bottom Ditching Be sure to ground the moldboard before retracting the centershiff lock pin. If no "V" ditch exists, make one to the desired depth of the flat bottom ditch. NOTE: The shoulder slope should be flatter than normal, ending at the finished shoulder line. 1. Tip the blade forward. 72

Privacy Statement
Press Release
Contact