TM 5380-263-14&P-3
DISASSEMBLY AND ASSEMBLY
WHEEL SPINDLES AND WHEEL SPINDLE HOUSINGS
4. Install the bolts, washers and nuts (6) that hold the
pins to the wheel spindle housing. Install the plugs
in the wheel lean arm with tooling .
5. Start the engine. Move the wheel lean cylinder rod
into position over the pin that holds the cylinder rod
to the wheel lean arm and the wheel lean bar.
Install the pin in the cylinder rod. Install the bolt,
washer and the retainer on the end of the pin.
6. Install the lock, nut, washer and bolt (4). Tighten
the bolt to a t torque of 185 10 lb.ft. (254 14 N-
m). Remove the lockpin from the wheel lean bar
and the front axle.
7. Put steering tie rod (5) in position in the wheel
spindle housing. Install the nut on the pin. Tighten
the nut to a torque of 90 lb.ft. (120 N.m). Always
tighten the nut to put the groove (slot) in alignment
with the hole in the pin. Install the cotter pin.
8. Put the steering cylinder in position in the wheel
spindle housing. Install the nut on the pin. Tighten
the nut to a torque of 100 10 Ib.ft. (135 14
N.m). Always tighten the nut to put the groove
(slot) in alignment with the hole in the pin. Install
the cotter pin.
9. Repeat Steps I through 8 for the other wheel
spindle and wheel spindle housing.
end by:
a) install front wheels
3-180
