TM 5380-263-14&P-3
VEHICLE SYSTEMS
WHEEL SPINDLES AND WHEEL SPINDLE HOUSINGS
INSTALL WHEEL SPINDLES AND WHEEL
SPINDLE HOUSINGS
Tools Needed
A
B
C
5P4197
Spacer
1
1P543
Nut
1
1P1833
Pulling Adapter
1
5F7353
Washer
1
9S5559
Nut
1
7F9540
Puller Assembly
1
1
5P3100
Pump Group (or electric) 1
1
1H3109
Leg
2
1H3107
Puller Assembly
1
5F7343
Bearing Puller Assembly
1
L-1774
Spacer
6
1P510
Driver Group
1
1. Install the bearings in wheel lean arm (1) with
tooling (A). Install the bearings even with the
surface that is toward the center of the wheel lean
arm.
CAUTION
Tooling (A) must be used when the bearings are
installed to prevent causing damage.
2. Install new O-ring seals and new seals in the top
and the bottom of wheel spindle housing (2).
Fasten a hoist to the housing. Put it in position on
the wheel lean arm. Install the thrust pack between
wheel spindle housing (2) and wheel lean arm (1)
at the upper junction.
3. Lower the temperature of the two pins that hold the
wheel spindle housing to the wheel lean arm.
Install pins (3) with tooling (B). Make sure the
groove in the pin is in alignment with the opening in
the wheel spindle housing.
3-179
