TM 5-3805-263-14&P-3
HYDRAULIC SYSTEM AND STEERING
Cylinders (Cont.)
8J1658 Cylinder (Ripper)
(1)
Torque for bolt with lubricant
on threads..............800 80 lb. ft. (1090 110 Nm)
(2)
Torque for crown with lubricant
on threads..........350 to 550 lb. ft. (470 to 750 Nm)
Torque for screw to keep
crown tight .........................25 3 lb. ft. (35 4 Nm)
(3)
Bore in a new cylinder.................... 4.000 +0.005 or
-0.002 in. (101.60 +0.13 or -0.05 mm)
Bore in a new head........................ 2.003 0.001 in.
(4)
(50.88 0.03 mm)
Diameter of a new rod ............... 1.9980 0.0015 in.
(50.75 +0.04 mm)
3G1853, Cylinder (Scarifier)
(1)
Torque for bolt with lubricant
on threads..............800 80 lb. ft. (1090 110 Nm)
(2)
Torque for crown with lubricant
on threads..........350 to 550 lb. ft. (470 to 750 Nm)
Torque for screw to keep
crown tight .........................25 3 lb. ft. (35 4 Nm)
(3)
Bore in a new cylinder.................... 3.000 +0.005 or
-0.002 in. (76.20 +0.13 or -0.05 mm)
Bore in a new head........................ 1.503 0.001 in.
(4)
(38.18 0.03 mm)
Diameter of a new rod ............... 1.4980 0.0015 in.
(38.04 +0.04 mm)
MOUNTING FOR ARTICULATION CYLINDER
(1)
Washers. .. Use washers needed at rod end (2) to
get articulation cylinder (3) level.
(4)
Bearing (one at each end of cylinder). . Do not use
an impact tool to install bearings.
3-103
