TM -3805-261-34
HYDRAULIC SYSTEM MAINTENANCE. (cont)
10-15.
Centershift Cylinder. (Sheet 2 Of 6)
REMOVAL
NOTE
All hose and tube assemblies
must be tagged before
disconnecting to aid in
installation. Cap all hose
and tube ends to prevent
contamination.
1.
Disconnect hose assembly (1,
Figure 10-121).
2.
Remove connector (2) and
preformed packing (3).
Discard
preformed packing (3).
3.
Disconnect hose assembly (4).
4.
Remove elbow (5), connector (6)
and preformed packing (7).
Discard preformed packing (7).
WARNING
Weight of Centershift
cylinder is approximately 80
pounds. Use adequate hoist
and sling for lifting.
Failure to follow this
procedure may cause INJURY.
If you are injured, seek
medical aid immediately.
5.
Attach hoist and sling to
cylinder (22) above circle
assembly. Remove slack from
sling.
Figure 10-121.
Go to Sheet 3
10-86
