TM 5-3805-261-34
HYDRAULIC SYSTEM MAINTENANCE.
10-12.
Circle Drive and Leaning Wheel Check Valves. (Sheet 2 of 3)
DISASSEMBLY
NOTE
Springs are under pressure.
Loosen plugs carefully to
keep springs from becoming
projectiles.
1.
Remove two items 1 and 2 as an
assembly (Figure 10-105).
2.
Remove and discard two preformed
packings (2) from plugs (1,
Figure 10-106).
3.
Remove two springs (3) and balls
(4, Figure 10-107).
4.
Using alignment punch and hammer,
remove seat (5) and piston (6)
from body (8, Figure 10-108).
5.
Using alignment punch and hammer
remove seat (7) from body (8).
CLEANING
Clean all parts. Refer to Chapter 2.
INSPECTION
Inspect all parts. Refer to Chapter 2.
Figure 10-105.
Figure 10-106.
Figure 10-107.
Figure 10-108.
Go to Sheet 3
10-73
