TM 5-3805-261-34
BRAKES MAINTENANCE. (cont)
6-4.
Parking Brake Actuator and Release Valve. (Sheet 2 of 6)
REMOVAL
WARNING
Do not disconnect the air
line from the parking brake
release valve until the air
pressure is zero. All air
must be bled from the air
tanks. Failure to follow
this procedure may cause
INJURY. If you are injured,
seek medical aid immediately.
NOTE
All hose and tube assemblies
must be tagged before
disconnecting to aid in
installation. Cap all hose
and tube ends to prevent
contamination.
1.
Disconnect hose assembly (1) from
elbow (7, Figure 6-3).
2.
Connect shop air line to elbow
(7) and apply pressure to relieve
release valve pressure.
3.
Remove cotter pin (2) from pin
(3).
4.
Remove pin (3) from rod end (14).
5.
Remove shop air line from elbow
(7).
6.
Remove two nuts (4), lockwashers
(5) and bolts (6) from bracket
(13).
7.
Remove elbow (7) and plug (8)
from release valve assembly.
Go to Sheet 3
6-12
Figure 6-3.
