TM 5-3805-261-34
REAR AXLE MAINTENANCE.
5-20.
Differential Lock Control Valve. (Sheet 3 of 5)
REMOVAL
4.
Remove hose assembly (6), elbow
(7) and preformed packing (8,
Figure 5-114) from top, center of
differential housing. Discard
preformed packing (8).
5.
Remove cap (9), nut (10) and
washer (11).
NOTE
All wire, cable and harness
assemblies must be tagged
before disconnecting to aid
in installation.
6.
Disconnect wire assembly (12) at
terminal.
7.
Remove two bolts (13), washers
(14) and clip (15).
8.
Remove items 16 thru 24 as an
assembly.
9.
Remove nut (16) and lockwasher
(17, Figure 5-115).
10.
Separate coil (18) from items 19
thru 24 as an assembly.
11.
Remove cartridge (19), seal kit
(20), plug (21), preformed
packing (22) and two preformed
packings (23) from valve (24,
Figure 5-116). Discard seal kit
(20) and preformed packings (22
and 23).
CLEANING
Clean all parts. Refer to Chapter 2.
INSPECTION
Inspect all parts. Refer to Chapter 2.
Figure 5-114.
Figure 5-115.
Figure 5-116.
Go to Sheet 4
5-93