TM 5-3805-261-34
TRANSMISSION MAINTENANCE. (cont)
5-5.
Control Cables. (Sheet 2 of 8)
REMOVAL
1.
Remove three bolts (1), washers
(2), cover (3) and gasket (4,
Figure 5-17) from front of
operator’ s panel console.
Discard gasket (4). Remove all
gasket material from mounting
surfaces.
2.
Loosen nut (8, Figure 5-18).
3.
Remove bolt (5), washer (6) and
rod end (7).
4.
Remove two nuts (8) and star
washer (9).
5.
Loosen nut (13).
6.
Remove bolt (10), washer (11) and
rod end (12).
7.
Remove two nuts (13) and star
washer (14).
NOTE
All wire, cable and harness
assemblies must be tagged
before disconnecting to aid
in installation.
8.
Remove lockwasher (15), nut (16),
lockwasher (17) and nut (18,
Figure 5-19).
9.
Remove bolt (19), washer (20) and
clip (21) from under right side
of cab.
10. Disconnect cables (55 and 56)
through cab floor.
Go to Sheet 3
5-18
Figure 5-17.
Figure 5-18.
Figure 5-19.
