TM 5-3805-261-34
WIRING AND HARNESS MAINTENANCE. (cont)
4-16.
Rear Signal Light and Back-up Alarm Harness. (Sheet 2 of 5)
REMOVAL
1.
Remove three nuts (1), washers
(2) and clips (3, Figure 4-85).
NOTE
All wire, cable and harness
assemblies must be tagged
before disconnecting to aid
in installation.
2.
Disconnect rear signal light and
back-up alarm harness assembly
(13) from main harness assembly.
3.
Remove bolt (4), washer (5) and
clip (6).
4.
Cut and discard cable strap (7).
5.
Disconnect rear signal light and
back-up alarm harness assembly
(13) from rear floodlight harness
assembly.
6.
Disconnect two wire assemblies
(8) from rear signal light and
back-up alarm harness assembly
(13, Figure 4-86).
7.
Remove rear signal light and
back-up alarm harness assembly
(13) from clip (14).
8.
Disconnect wire assembly (9) from
rear signal light and back-up
alarm harness assembly (13).
9.
Remove rear signal light and
back-up alarm harness assembly
(13) from clip (15).
10.
Disconnect wire assembly (10)
from rear signal light and
back-up alarm harness assembly
(13).
Figure 4-86.
Go to Sheet 3
4-82
Figure 4-85.
