FRAME MAINTENANCE. (cont) - TM-5-3805-261-34

FRAME MAINTENANCE. (cont) - TM-5-3805-261-34_1032

FRAME MAINTENANCE. (cont) - TM-5-3805-261-34_1034

TM-5-3805-261-34 Grader Heavy Road Motorized (Caterpillar Model 130 G) Manual
Page Navigation
986

TM 5-3805-261-34 FRAME MAINTENANCE. (cont) 16-3. Articulation Hitch Bearing. (Sheet 6 of 7) INSTALLATION (cont) 10. Install items 10 thru 8 as an assembly (Figure 16-30) in lower pin bore by raising floor jack. 11. Using clean grease, lubricate new seal (6, Figure 16-34) and position with lip facing down on cap (5). 12. Using suitable drive plates and hammer, install new seal (6) on cap (5). 13. Position items 6 and 5 as an assembly over bearing (8, Figure 16-31) on top of lower pin bore of front frame. 14. Install three of seven lock- washers (4) and three of seven bolts (3), with one but no more than two holes between three bolts (3). Tighten three of seven bolts (3) to 65 ft-lb torque. 15. Insert feeler gage between cap (5) and front frame near each of three of seven bolts (3) and measure gap between cap (5, Figure 16-32) and front frame. 16. Remove three of seven bolts (3), lockwashers (4) and items 6 and 5 as an assembly (Figure 16-31). Go to Sheet 7 16-20 Figure 16-32. Figure 16-31. Figure 16-30. Figure 16-34.

Privacy Statement
Press Release
Contact