TM 5-3805-261-23-2
SERVICE BRAKES MAINTENANCE - CONTINUED
0313 00
ASSEMBLY - CONTINUED
31.
Install seal (6) on cover (7).
1
32.
Coat seal (6) with grease.
33.
Install three new lockwashers (8), bolts (9), plate (10),
2
new lockwasher (11), and bolt (12).
3
34.
Install cone roller (5) over spindle (33).
4
5
6
33
7
8
13
9
10
11
12
397-1920
NOTE
The sprocket for the front service brake and wheel spindle housing must be installed with teeth next to cover.
The sprocket for the rear service brake and wheel spindle housing must be installed with teeth away from
cover.
35.
Install sprocket (4) over splines on spindle (33).
2
4
36.
Install retainer (2) and three bolts (1). Tighten bolts to
35 lb-ft (47 Nm) while turning housing (13).
37.
Remove three bolts (1) and retainer (2).
38.
Use a caliper to measure distance between end of
sprocket (4) and spindle (33).
SHIM(S)
39.
Install shim(s) (3), which have total thickness equal to
33
397-2500
distance measured in step 38 minus 0.010 to 0.015 in.
(0.25 to 0.38 mm).
40.
Install retainer (2) and three bolts (1). Tighten bolts to
192 lb-ft (260 Nm).
41.
Install service brake and wheel spindle housing assembly (WP 0314 00).
0313 00-14