TM 5-3805-261-23-2
FINAL DRIVE ASSEMBLY REPLACEMENT - CONTINUED
0309 00
INSTALLATION - CONTINUED
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during proce-
dure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may cause injury or death to per-
sonnel.
NOTE
Tandem housing weighs 2,300 lb (1,043 kg).
23.
Install two link brackets in tandem housing (8).
24.
Use sling to position tandem housing (8) on bottom-rear-left of machine.
25.
Install new thrust washer (3), shim(s) (4), retainer (5), 16 washers (7), and bolts (6).
26.
Apply grease to new thrust washer (3) after installation. Adjust shim(s) (4) to provide 0.0 to 0.0025 in (0.0 to 0.064 mm)
end play between inner housing (23) and outer housing (11). Tighten 16 bolts (6) to 260 to 280 lb-ft (353 to 380 Nm).
27.
Remove link brackets.
LINK BRACKETS
8
3
4
5
6
23
11
397-4238
7
28.
Install roller bearing (1) and new preformed packing
2
1
(2).
397-4220
29.
Install drive sprockets (WP 0308 00).
END OF WORK PACKAGE
0309 00-14