TM 5-3805-261-23-2
GOVERNOR CONTROLS MAINTENANCE - CONTINUED
0282 00
REMOVAL - CONTINUED
37.
Remove four nuts (66), washers (67), three clips (68), two plates (69), and clamps (70) from front and rear of articula-
tion area.
38.
Separate cable end (53) from left and right clamps (70) and pull cable through articulation area.
39.
Remove bolt (65), washer (71), and clip (72) from under right side of operator's compartment.
40.
Remove bolt (64), washer (63), and clip assembly (62) from under right side of operator's compartment. Leave clip
assembly mounted to hydraulic hose.
41.
Remove five bolts (61), washers (60), cover (59), and gasket (58). Discard gasket.
42.
Remove bolt (75) and washer (56).
43.
Separate rod end (57) and lever (54).
44.
Loosen nut (73).
45.
Remove rod end (57) and nut (73).
46.
Remove nut (74) from inside housing (55).
NOTE
For Type II machines, cable is divided between sections of machine. Either part of cable can be replaced
separately.
0282 00-6