TM 5-3805-261-23-2
ROCKER ARM ASSEMBLY MAINTENANCE - CONTINUED
0273 00
INSTALLATION
1.
Install two new plugs (58) in ends of shaft (7). Tap in with hammer until flush with ends of shaft.
2.
Install ring (42), washer (43), new spring tension washer (44), and washer (45) on shaft (7).
3.
Install screw (47) and new locknut (46) on rocker arm (57). Hand-tighten locknut.
4.
Install rocker arm assembly (57) on shaft (7).
NOTE
Align bracket with large hole on end.
5.
Position bracket (48) on shaft (7).
6.
Install shaft (56) in bracket (48). Shaft must extend 0.378 in. (9.60 mm) out of bracket.
7.
Install new preformed packing (55) in bracket (48).
8.
Install screw (52) and new locknut (54) on rocker arm (53). Hand-tighten locknut.
9.
Install rocker arm assembly (53).
10.
Install washer (51), spring (50), and washer (49) on shaft (7).
11.
Install screw (39) and new nut (41) on rocker arm
(40). Hand-tighten nut.
12.
Install rocker arm assembly (40).
13.
Install pin (37) in bracket (38); pin must extend 0.23
7
in. (5.8 mm) out of bracket.
14.
Install bracket (38).
41
15.
Install screw (35) and nut (31) on rocker arm (36).
Hand-tighten nut.
16.
Install rocker arm assembly (36).
17.
Install washer (34), spring (33), and washer (32).
40
31
39
38
37
36
35
34
33
397-1316
32
0273 00-5