TM 5-3805-261-23-1
SIDESHIFT CYLINDER AND MOUNTING REPLACEMENT - CONTINUED
0247 00
REMOVAL - CONTINUED
14.
Remove nut (27), washer (26), bolt (23), pin (18), and washers (28 and 19).
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during proce-
dure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may cause injury or death to per-
sonnel.
NOTE
Old style bracket weighs 72 lb (33 kg); new style bracket weighs 50 lb (23 kg).
15.
With assistance, attach sling to bracket (24) and position floor jack under side shift cylinder (13).
NOTE
New style bracket (24) does not have nut (17) and washers (15 and 16).
16.
Remove cotter pin (20), nut (21), washer (22), nut (17), washers (16 and 15), nut (14), bracket (24), and washer (25)
from machine. Discard cotter pin.
17.
Set bracket (24) on ground and remove sling from bracket.
13
SLING
14
15
16
17
18
19
20
21
28
27 26
FLOOR JACK
397-1615
25
23
22
24
OLD STYLE BRACKET SHOWN
0247 00-4