TM 5-3805-261-23-1
FRONT WIPER (LOWER) MAINTENANCE (CCE MACHINE) - CONTINUED
0206 00
REMOVAL - CONTINUED
15.
Remove two nuts (38) and lockwashers (39) from
studs (40). Discard lockwashers.
16.
Remove two linkages (1) and spacer (41).
35 36 37
33 34
NOTE
If necessary, open lower windshield to
perform the next step.
44
Hold two stops while removing nuts.
32
17.
Remove two nuts (37) and washers (36).
18.
Remove two stops (33) from machine.
42
19.
Remove two washers (35) and nuts (34) from stops
(33).
43
38
DISASSEMBLY
44
39
1.
Remove two clips (43).
43
2.
Separate two washers (42), studs (40), links (44), and
1
arm (32).
42
40
41
397-638
CLEANING AND INSPECTION
Clean and inspect all parts in accordance with WP 0020 00.
ASSEMBLY
1.
Position arm (32), two links (44), studs (40), and washers (42). Right link should be down and left link up.
2.
Install two clips (43).
INSTALLATION
1.
Install two nuts (34) and washers (35) on stops (33).
2.
Install two stops (33) in machine.
3.
Install two washers (36) and nuts (37) on stops (33) in front of steering column in interior of cab.
4.
Position spacer (41) and two linkages (1). Holes of linkages go on studs (40).
5.
Install two new lockwashers (39) and nuts (38) on studs (40).
6.
Install new gasket (28), flange (29), four new lockwashers (27), and screws (26).
7.
Position shaft of wiper motor (22) on arm (32) and install washer (31) and nut (30).
8.
Install wiper motor (22).
9.
Connect three wire assemblies (25) at terminals.
10.
Install cover (23) and four screws (24) in front of steering column in interior of cab.
11.
Connect battery cables (WP 0125 00).
0206 00-5
