TM 5-3805-261-23-1
FRONT WHEELS REPLACEMENT - CONTINUED
0166 00
CLEANING AND INSPECTION
Clean and inspect all parts in accordance with WP 0020 00.
INSTALLATION
1.
Install sling on front wheel (3).
2.
Position front wheel (3) on machine.
3.
Install 10 washers (2) and nuts (1).
4.
Use hydraulic jack to lift machine and remove jack
stand.
5.
Lower front wheel (3) to ground and remove hydraulic
jack.
WARNING
Whenever any lug nuts require tightening
TIGHTENING PATTERN
or a wheel has been removed and replaced,
397-2502
all lug nuts must be tightened to the
required torque. Failure to follow this
warning may result in serious injury to
personnel or damage to equipment.
NOTE
Tightening pattern is the same for all wheel assemblies.
After operating vehicle for 50 to 100 miles (80 to 160 km), tighten lug nuts again.
6.
Tighten 10 bolts (1) evenly to 450+/-30 lb-ft (610+/-41 Nm) or tighten 10 nuts to 365 + 25 lb-ft (495 + 34 Nm), in accor-
dance with tightening pattern.
7.
Remove sling.
8.
Check pressure of tire (TM 5-3805-261-10).
END OF WORK PACKAGE
0166 00-3