TM 5-3805-261-23-1
OIL LEVEL GAUGE TUBE ASSEMBLY REPLACEMENT - CONTINUED
0027 00
REMOVAL - CONTINUED
3
3.
Remove two elbows (4) and bolt (3).
4
397-089
4.
Disconnect air line (9).
5.
Remove bolt (10) that secures clamp on air line (9).
6.
Loosen nut (6) and remove tube assembly (5).
NOTE
Remove nut and sleeve only if inspection indicates leakage around sleeve.
7.
Remove nut (6) and cut and discard sleeve (7) from tube assembly (5).
8.
Remove connector (8) from cylinder block.
CLEANING AND INSPECTION
Clean and inspect all parts in accordance with WP 0020 00.
INSTALLATION
1.
Install connector (8) in cylinder block on lower left
10
side of engine.
5
2.
Install new sleeve (7) and nut (6) on tube assembly
(5).
6
7
3.
Position tube assembly (5) on left side of engine,
install bolt (3), and tighten nut (6).
9
4.
Install bolt (10) to secure clamp on air line (9).
8
5.
Connect air line (9).
397-090
6.
Install two elbows (4).
0027 00-2