TM 5-3805-261-20HYDRAULIC SYSTEM MAINTENANCE.15-4.CircleDriveMotorAssembly.(Sheet 2 of 3)REMOVALNOTEAll hose and tube assemblies mustbe tagged before disconnecting toaid in installation. Cap all hose andtube ends to prevent contamination.1.Disconnect hose assemblies (1 and 2) atconnectors from circle drive motor (5,Figure 15-1).2.Remove four bolts (3), washers(4) andcircle drive motor (5).CLEANINGClean all parts. Refer to Chapter 2.INSPECTIONInspect all parts. Refer to Chapter 2.INSTALLATION1.Install circle drive motor (5, Figure 15-1) inleft rear frame of circle drive. Hose portsface outside left.2.Install four washers (4) and bolts (3).3.Connect hose assemblies (2 and 1) atconnectors on circle drive motor (5).Figure 15-1.Go to Sheet 315-9
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
