INSTALLATION - TM-5-3805-261-20

TM-5-3805-261-20 Grader Heavy Road Motorized (Caterpillar Model 130 G) Manual
Page Navigation
648

TM 5-3805-261-20 TRANSMISSION MAINTENANCE. (cont) 8-5. Transmission Modulation Control Housing. (Sheet 4 of 6) REMOVAL (cont) 10. Loosen nut (23) and remove housing (17) from pedal (24, Figure 8-16). 11 Remove nut (23) and bolt (25) from pedal (24). CLEANING Clean all parts. Refer to Chapter 2. INSPECTION Inspect all parts. Refer to Chapter 2. INSTALLATION 1. Pack rollers of bearings (21 and 22, Figure 8-17) completely with automotive grease. 2. Coat outside of bearings (21 and 22) with anti-seize compound. 3. Using an arbor press, install bearings (21 and 22) in housing (17, Figure 8-15). 4. Position lever (15) inside housing (17) before shaft (16, Figure 8-13) is installed. 5. Install shaft (16). End of shaft (16) should be 0.098 inch below flat side of housing. 6. Install key (11) in keyway of lever (12, Figure 8-11). 7. Install bolt (10) on shaft (16). Go to Sheet 5 Figure 8-16 8-20 Figure 8-17 Figure 8-15 Figure 8-13 Figure 8-11

Privacy Statement
Press Release
Contact