TM 5-3805-261-20
TRANSMISSION MAINTENANCE. (cont)
8-4.
Transmission Modulation Control. (Sheet 3
of 5)
CLEANING
Clean all parts. Refer to Chapter 2.
INSPECTION
Inspect all parts. Refer to Chapter
2.
INSTALLATION
1.
Install pedal (7, Figure 8-5).
2.
Insert upper end of spring (6) on pedal (7).
3.
Install lower end of spring (6)around bolt in
cab floor frame weldment.
4.
If boot (5) or washer (4) required
replacement, attach boot (5) to washer (4,
Figure 8-4) with adhesive.
5.
Install boot (5) and washer (4) as an
assembly over pedal (7) lifting up left front
corner of rubber floor mat. Return floor mat
to original position.
6.
Install thread (3), two washers (2) and bolts
(1, Figure 8-3).
Figure 8-5
Figure 8-4
Figure 8-3
Go to Sheet 4
8-14