TM 5-3805-261-20
SENDING UNITS AND WARNING SWITCHES MAINTENANCE. (cont)
7-96.
Blackout and Service Stop Light Switches. (Sheet 2 of 3)
REMOVAL
NOTE
The
following
is
a
maintenance
procedure for the service stop light
switch. The maintenance procedure
for the blackout stop light switch is
identical.
1.
Remove two nuts (1) and washers (2,
Figure 7-145) from under right side of cab.
NOTE
All
wire,
cable
and
harness
assemblies must be tagged before
disconnecting to aid in installation.
2.
Disconnect two wire assemblies (3).
3.
Remove service stop light switch (4).
4.
Remove bushing (5).
CLEANING
Clean all parts. Refer to Chapter 2.
INSPECTION
Inspect all parts. Refer to Chapter 2.
Figure 7-145
Go to Sheet 3
7-236
