TM 5-3805-261-20
SENDING UNITS AND WARNING SWITCHES MAINTENANCE.
7-95.
Hydraulic Oil Temperature Switch. (Sheet 2 of 3)
REMOVAL
1. Remove two screws (1) and washers (2) from
switch (4, Figure 7-144) on right side of hydraulic tank.
NOTE
All
wire,
cable
and
harness
assemblies must be tagged before
disconnecting to aid in installation.
2.
Disconnect two wire assemblies (3).
3.
Remove switch (4) from hydraulic tank.
4.
Remove and discard performed packing (5).
CLEANING
Clean all parts. Refer to Chapter 2.
INSPECTION
Inspect all parts. Refer to Chapter 2.
Figure 7-144
Go to Sheet 3
7-233
