TM 5-3805-261-20
SENDING UNITS AND WARNING SWITCHES MAINTENANCE.
7-94.
Fuel Pressure Switch. (Sheet 2 of 2)
REMOVAL
1.
Open right side engine door.
2.
Remove two screws (1) from switch (3,
Figure 7-143) on secondary fuel filter on
right side of engine.
NOTE
All
wire,
cable
and
harness
assemblies must be tagged before
disconnecting to aid in installation.
3.
Disconnect two wire assemblies (2) at
terminals from switch (3).
4.
Remove switch (3) from elbow (4).
CLEANING
Clean all parts. Refer to Chapter 2.
INSPECTION
Inspect all parts. Refer to Chapter 2.
INSTALLATION
1.
Install switch (3) on elbow (4).
2.
Position
two
wire
assemblies
(2)
at
terminals on switch (3).
3.
Install two screws (1).
NOTE
Return
130G
Grader
to
original
equipment condition.
Figure 7-143
End of Task
7-231