REMOVAL - TM-5-3805-261-20

TM-5-3805-261-20 Grader Heavy Road Motorized (Caterpillar Model 130 G) Manual
Page Navigation
390

TM 5-3805-261-20 SUPPLEMENTAL STEERING MAINTENANCE. 7-50. Pump Motor. (Sheet 2 of 3) REMOVAL 1. Open left side engine door. 2. Remove two nuts (1) and lockwashers (2, Figure 7-67) from front, left side of engine compartment. NOTE All wire, cable and harness assemblies must be tagged before disconnecting to aid in installation. 3. Disconnect wire assemblies (3 and 4). 4. Remove four bolts (5) and lock- washers (6, Figure 7-68). 5. Remove pump assembly (7) from motor assembly (15) along with attached hose assemblies. Position pump assembly (7) out of the way. 6. Remove gasket (8) and coupler (9). Discard gasket (8). Remove all gasket material from mounting surfaces. NOTE Support motor assembly while removing attaching hardware. Weight of motor assembly is 42 lbs. 7. Remove four nuts (10), three washers (11), bolts (12), bolt (13), washer (14) and motor assembly (15) from bracket (16, Figure 7-69). Figure 7-69 Go to Sheet 3 Figure 7-68 Figure 7-67 7-127

Privacy Statement
Press Release
Contact