COOLING SYSTEM MAINTENANCE. (cont) - TM-5-3805-261-20

COOLING SYSTEM MAINTENANCE. (cont) - TM-5-3805-261-20_284

COOLING SYSTEM MAINTENANCE. (cont) - TM-5-3805-261-20_286

TM-5-3805-261-20 Grader Heavy Road Motorized (Caterpillar Model 130 G) Manual
Page Navigation
240

TM 5-3805-261-20 COOLING SYSTEM MAINTENANCE. (cont) 6-42. Temperature Regulator. (Sheet 3 of 3) TESTING NOTE Water must be kept at a constant temperature of 190 degrees F or ten minutes and regulator cannot touch the bottom or sides of the pan. Submerge regulator (8, Figure 6-103) in water. After ten minutes, remove regulator (8) and measure distance regulator (8) has opened. If distance is less than 0.375 inch, replace regulator (8). INSTALLATION 1. Install regulator (10, Figure 6-102). Pyramid part of regulator (12) faces up. 2. Install plug (9) in housing (5). 3. Install housing (5) and new gasket (8). 4. Install four washers (4) and bolts (3). 5. Install washer (7) and bolt (6) to fuel tank clip weldment. 6. Connect hose (1) by sliding down from tube (9) onto housing (5). 7. Tighten two clamps (2). NOTE Return 130C Grader to original equipment condition. Figure 6-102. End of Task Figure 6-103. 6-148

Privacy Statement
Press Release
Contact