TM 5-3805-261-20
COOLING SYSTEM MAINTENANCE.
6-42.
Temperature Regulator. (Sheet 2 of 3)
REMOVAL
1.
Loosen two clamps (2, Figure 6-102) in front
left, top of engine.
NOTE
All hose and tube assemblies must be
tagged before disconnecting to aid in
installation. Cap all hose and tube
ends and plug all open ports to
prevent contamination.
2.
Disconnect hose (1) from housing (5) by
sliding up on tube (11).
3.
Remove bolt (6) and washer (7) from fuel
tank clip weldment.
4.
Remove four bolts (3) and washers (4).
5.
Remove gasket (8) and housing (5) from
cylinder head. Discard gasket (8). Remove
all gasket material from mounting surfaces.
6.
Remove plug (9) from housing (5).
7.
Remove regulator(10).
CLEANING
Clean all parts. Refer to Chapter 2.
INSPECTION
Inspect all parts. Refer to Chapter 2.
Figure 6-102.
Go to Sheet 3
6-147
