TM 5-3805-261-20
FUEL SYSTEM MAINTENANCE.
6-28.
Ether Starting Aid Assembly. (Sheet 2 of 4)
REMOVAL
1.
Remove two bolts (1), washers (2) and
clamp (3, Figure 6-79) in rear, right side of
fuel tank.
NOTE
All
wire,
cable
and
harness
assemblies must be tagged before
disconnecting to aid in installation.
2.
Disconnect harness assembly (4) from
valve (12).
3.
Remove bolt (5), washer (6) and clips (7
and 8) from tube (19).
4.
Remove connector (9) and tube (19) from
valve (12).
NOTE
Do not remove connector from tube
unless inspection shows need for
replacement.
5.
Remove connector (9) from tube (19).
6.
Remove two bolts (10), washers (11) and
valve (12).
7.
Remove bolt (13), washer (14) and clip (15,
Figure 6-80) from right rear, under fuel tank.
8.
Remove bolt (16), washer (17) and clip (18)
from left front, under fuel tank.
Figure 6-80.
Go to Sheet 3
6-105
Figure 6-79.
