INSTALLATION - TM-5-3805-261-20

Section V. EXHAUST SYSTEM TROUBLESHOOTING

TM-5-3805-261-20 Grader Heavy Road Motorized (Caterpillar Model 130 G) Manual
Page Navigation
199

TM 5-3805-261-20 FUEL SYSTEM MAINTENANCE. 6-28. Ether Starting Aid Assembly. (Sheet 4 of 4) INSTALLATION 3. Install clip (23), washer (22) and bolt (21) securing tube (24) to base of turbocharger air pipe. 4. Connect tube assembly (20) to tube (24, Figure 6-80) in rear, left side of engine compartment. 5. Position tube (19) in vehicle and connect to tube assembly (20). 6. Install clip (18), washer (17) and bolt (16) securing tube (19) in left front, under fuel tank. 7. Install clip (15), washer (14) and bolt (13) securing tube (19) to right rear, under fuel tank. 8. Install valve (12), two washers (11) and bolts (10, Figure 6-79) on right rear of fuel tank. 9. Install connector (9) on tube (19), if removed. 10. Install tube (19) and connector (9) on valve (12). 11. Install clips (8 and 7), washer (6) and bolt (5) securing tube (19) and harness assembly (4) to fuel tank. 12. Connect harness assembly (4) to valve (12). 13. Install clamp (3), two washers (2) and bolts (1). NOTE Return 130G Grader to original equipment condition. Figure 6-79. End of Task 6-107

Privacy Statement
Press Release
Contact