INSTALLATION - TM-5-3805-261-20

TM-5-3805-261-20 Grader Heavy Road Motorized (Caterpillar Model 130 G) Manual
Page Navigation
1130

TM 5-3805-261-20 SCARIFIER ASSEMBLY MAINTENANCE. (cont.) 17-13. Scarifier Actuating Assembly. (Sheet 6 of 9) CLEANING Clean all parts. Refer to Chapter 2. INSPECTION Inspect all parts. Refer to Chapter 2. INSTALLATION NOTE Step 1 requires two mechanics. 1. Position plate (30) over two brackets (33, Figure 17-60). 2. Install four blocks (29), bolts (28), washers (27) and nuts (26) to secure plate (30) to frame. Tighten bolts (28) to 900 ft-lb torque. 3. Remove hoist and slings. NOTE If installing an arm without alignment marks, install arm at a 90-degree angle to the shaft drive arm (Figure 17-68). 4. Install arm (25) on shaft (36, Figure 17-57), making sure that scribed alignment marks are aligned. Figure 17-68. Figure 17-68. Figure 17-57. Go to Sheet 7 17-46

Privacy Statement
Press Release
Contact