TM 5-3805-261-20
SCARIFIER ASSEMBLY MAINTENANCE. (cont.)
17-13.
Scarifier Actuating Assembly. (Sheet 8 of 9)
INSTALLATION (cont.)
NOTE
Addition of one more shim to shims
removed results in proper amount of
free play between ball and cap.
11.
Add one shim (19, Figure 17-70) and repeat
steps 14 thru 18 until two bolts (16) can be
tightened to remove free play without
allowing cap (18) to touch sleeve (20).
12.
Install cap (18), two washers (17) and bolts
(16) if removed to add additional shim(s)
(19).
13.
Install lubrication fitting (15) in link (14,
Figure 17-54).
14.
Install link (14) in sleeve (20) and position
socket of link (14) over ball of drawbar.
15.
Install shim(s) (13), cap (12), two washers
(11) and bolts (10).
16.
Repeat steps 16 thru 19 to adjust free play
(clearance) between cap (12) and ball.
17.
Install bolt (9) and nut (8, Figure 17-53).
18.
Install pin (7) and pin assembly (6).
Figure 17-54.
Figure 17-53.
Go to Sheet 9
Figure 17-70.
17-48
