TM 5-3805-261-10
ADVANCED OPERATION AND OPERATOR TIPS - CONTINUED
0006 00
TRAVELING AND EARTH MOVING OPERATIONS - CONTINUED
Extreme Side Reach
CAUTION
Make sure the blade is lowered to the ground before retracting the centershift lock pin. Failure to follow this
caution may result in damage to machine.
NOTE
The following steps are for extreme side reach to the right. For extreme left side reach, position the center-
shift lock pin and blade to the far left.
1.
Move the centershift lock pin to the far right position. Move the centershift lever lock pin lever to the INDEX and RUN
position.
2.
Sideshift the blade to the far right position.
3.
Lower the blade to the desired depth and set it at an angle to deliver the material to the side.
Front Mounted Scarifier Operation
CAUTION
When using the scarifier, the frame must be straight.
When carrying the scarifier in the fully raised position, do not allow the scarifier beam to contact the
drawbar.
Raise the scarifier when turning. Failure to follow these cautions may cause damage to machine.
1.
Enter the material gradually, while traveling in a straight line.
2.
Use all the shanks in light material, fewer shanks in heavier material.
3.
Keep the scarifier as deep as conditions permit. Match travel speed to the load.
4.
Break up paving by digging under the surface and lifting the scarifier.
5.
All the teeth can remain in the front scarifier when level grading with the blade.
CAUTION
Do not reverse the scarifier teeth. They may impact frame.
6.
Remove all the front scarifier teeth and set the link rods at the shortest distance when reverse blading or ditching.
7.
Clean the scarifier when dirt begins to accumulate.
END OF WORK PACKAGE
0006 00-33
