DISASSEMBLY AND ASSEMBLY
4. Put clean engine oil on the valve stems. Install
the valve, spring and rotocoil in the cylinder
To prevent possible personal injury, make sure
the locks are in their correct position on the
valve stem when the compressor is released.
Put tooling (C) in position on the valve spring
and put the spring in compression. Use tooling
(D) to install the locks on the valve stem.
Remove tooling (D) and hit the top of the valve
with a plastic hammer to be sure the locks are in
their correct position on the valve.
Do Steps 4. 5 and 6 again for the remainder of
Install brackets (2) for the fuel injection line
clamps on the cylinder head.
Put 5P3413 Pipe Sealant on the threads of
water temperature sending unit (3) and install
the sending unit in the cylinder head.
Install lifting brackets (4) on the cylinder head.
Use tool (E) to install carbon dam (5) on the
fuel injection nozzles. Install seal (6) on the
fuel injection nozzles.
Put fuel injection nozzles (7) in position in the
cylinder head and install the bolt that holds
each nozzle in place.
a) install cylinder head