DISASSEMBLY AND ASSEMBLY
9. Fasten a hoist to cylinder head (11). Remove
the bolts and cylinder head (11) from the en-
gine. The weight of the cylinder head is 61 kg
Do not put the cylinder head down on a flat
surface. This can cause damage to the fuel in-
INSTALL CYLINDER HEAD
NOTE: Always install a new gasket between the
spacer plate and cylinder block before the cylinder
head is installed. See REMOVE SPACER PLATE.
Thoroughly clean the spacer plate and bottom
surface of the cylinder head. Install a new head
gasket, water ferrules (1) and the O-ring seal
on the hollow dowel.
Install a new gasket on the water inlet elbow.
Fasten a hoist to cylinder head and put it in
position on the cylinder block. Make sure the
cylinder head is in alignment with the dowels in
the cylinder block.
Put 2P2506 Anti-Seize Compound Thread Lu-
bricant on all the head bolts and rocker shaft
bolts. Install the head bolts and washer that
hold the cylinder head in place but do not
tighten at this time.
Remove the bolt from the lifting bracket and
connect wire harness (2) to it. Install the bolt on
the lifting bracket.
Connect clip (3) to the cylinder head.
Install tube assemblies (4) and (6) to the engine
Connect clip (5) to the cylinder head.