TM 5-3805-293-23-4
0237
REMOVAL CONTINUED
12. Remove nut (Figure 6, Item 1), washer (Figure 6, Item 8), cable (Figure 6, Item 2), bus bar plate (Figure 6, Item
7), and lockwasher (Figure 6, Item 9) from circuit breaker (Figure 6, Item 6). Discard lockwasher.
13. Remove two screws (Figure 6, Item 5), washers (Figure 6, Item 4), and circuit breaker (Figure 6,
Item 6) from upper cover (Figure 6, Item 3).
Figure 6. 150-Amp Circuit Breaker.
0237
END OF TASK
CLEANING AND INSPECTION
000237
1. Clean and inspect all mechanical parts IAW Mechanical General Maintenance Instructions (WP 0346).
2. Clean and inspect all electrical parts IAW Electrical General Maintenance Instructions (WP 0347).
END OF TASK
INSTALLATION
000237
N OT E
Install wires and cables as tagged during removal.
1. Install circuit breaker (Figure 6, Item 6), two washers (Figure 6, Item 4), and screws (Figure 6, Item 5) on upper
cover (Figure 6, Item 3).
2. Install new lockwasher (Figure 6, Item 9), bus bar plate (Figure 6, Item 7), cable (Figure 6, Item 2), washer
(Figure 6, Item 8), and nut (Figure 6, Item 1) on circuit breaker (Figure 6, Item 6).