TM 5-3805-293-23-4
0220
CLEANING AND INSPECTION
000220
Clean and inspect all parts IAW Mechanical General Maintenance Instructions (WP 0346).
END OF TASK
INSTALLATION
000220
N OT E
Install wires and junction blocks as tagged during removal.
1. Install bracket (Figure 7, Item 5), three washers (Figure 7, Item 3) and bolts (Figure 7, Item 4) on platform
(Figure 6, Item 1).
2. Install two gaskets (Figure 7, Item 20), junction blocks (Figure 7, Item 6), eight washers (Figure 7, Item 19),
and screws (Figure 7, Item 18) on platform (Figure 6, Item 1).
3. If arctic heater is installed, install battery cable (Figure 7, Item 13), clamp (Figure 7, Item 12), washer (Figure 7,
Item 10) and bolt (Figure 7, Item 11) on platform (Figure 7, Item 1).
4. If arctic heater is installed, install battery cable (Figure 7, Item 13), washer (Figure 7, Item 8) and nut (Figure 7,
Item 7) on junction block (Figure 7, Item 6).
5. Position boot (Figure 7, Item 9) on battery cable (Figure 7, Item 13).
6. Install ether bottle clamp (Figure 7, Item 14), two washers (Figure 7, Item 16) and bolts (Figure 7, Item 15) on
platform (Figure 7, Item 1).
7. Install grommet (Figure 7, Item 2), hydraulic tank breather (Figure 7, Item 17), three clamps (Figure 7, Item 21),
washers (Figure 7, Item 22) and bolts (Figure 7, Item 23) on platform (Figure 7, Item 1).
0220-8