TM 5-3805-293-23-4
0192
ASSEMBLY
000192
Install new inner gasket (Figure 4, Item 4), mounting plate (Figure 4, Item 5), new outer gasket (Figure 4, Item 6),
eight washers (Figure 4, Item 2), four bolts (Figure 4, Item 1), and nuts (Figure 4, Item 7) on NATO slave receptacle
(Figure 4, Item 3).
END OF TASK
INSTALLATION
000192
WARN I N G
Plus and minus symbols are stamped in NATO receptacle near battery cable terminal
connectors. Install NATO receptacle on machine so positive terminal connector faces front
of machine and negative terminal connector faces rear of machine. Failure to follow this
warning may result in injury or death to personnel or damage to equipment.
C AU T I O N
Install flat side of inner gasket against NATOreceptacle mounting flange. Failure to follow
this caution may result in damage to inner gasket.
Seat raised lip on inner gasket in hole on mounting plate before tightening retaining
hardware. Failure to follow this caution may result in damage to inner gasket.
N OT E
Negative battery cable attaches to right side of NATO receptacle. Right side of NATO
receptacle faces rear of machine. Positive battery cable attaches to left side of NATO
receptacle. Left side of NATO receptacle faces front of machine.
1. Install mounting plate (Figure 3, Item 3), four washers (Figure 3, Item 1), and bolts (Figure 3, Item 2) on
machine.
2. Install positive battery cable (Figure 5, Item 3), new lockwasher (Figure 5, Item 6), and bolt (Figure 5, Item 5)
on NATO receptacle (Figure 5, Item 7).
3. Install protective cover (Figure 5, Item 4) over battery cable connector terminal on positive battery cable
Figure 5, Item 3).
4. Install negative battery cable (Figure 5, Item 2), new lockwasher (Figure 5, Item 8), and bolt (Figure 5, Item 9)
on NATO receptacle (Figure 5, Item 7)
5. Install protective cover (Figure 5, Item 1) over battery cable connector terminal on negative battery cable
(Figure 5, Item 2).
0192