TM 5-3805-293-23-3
0165
CLEANING AND INSPECTION
000165
1. Clean and inspect all mechanical parts IAW Mechanical General Maintenance Instructions (WP 0346).
2. Clean and inspect all electrical parts IAW Electrical General Maintenance Instructions (WP 0347).
END OF TASK
INSTALLATION
000165
Use extreme caution when handling heavy parts. Provide adequate support and use
assistance during procedure. Ensure any lifting device used is in good condition and of
suitable load capacity. Keep clear of heavy parts supported only by lifting device. Failure
to follow this warning may cause injury or death to personnel.
N OT E
AWD piston motor weighs approximately 100 lb (45.5 kg).
1. Install new O-ring (Figure 13, Item 3) on AWD piston motor (Figure 13, Item 4).
2. Remove wiring harness connector (Figure 13, Item 5) from AWD piston motor (Figure 13, Item 4), sliding
upward.
3. With assistance, install AWD piston motor (Figure 13, Item 4) on machine.
4. Install two washers (Figure 13, Item 2) and bolts (Figure 13, Item 1) on AWD piston motor (Figure 13, Item 4).
5. Install wiring harness connector (Figure 13, Item 5) from AWD piston motor (Figure 13, Item 4).
Figure 13. All-Wheel Drive Piston Motor.
0165
Change 1