TM 5-3805-293-23-2
0031
Table 1. Implement Code (2200-00 TO 2954-14) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2201-03 Right Steering Cyl-
Test Step 7. Test for Open Cab
inder Position Sensor Volt-
Lower Wiring Harness to Imple-
age Above Normal -
ment ECM.
Continued
1. Using a digital multimeter, mea-
Resistance Less Than 5.0 Ohms -
sure resistance between cab
Proceed to Test Step 8.
lower wiring harness connector P-
Resistance 5.0 Ohms or Greater -
C39 (WP 0009, Figure 70) termi-
Cab lower wiring harness is open,
nal 16 and machine ground.
replace cab lower wiring harness (WP
Resistance should be less than
0266).
5.0 Ohms.
Remove jumper wire between UC-C2
(WP 0009, Figure 196) terminal 2 and
machine ground.
Connect the steering position sensor
harness UC-C2 (WP 0009, Figure
196) to right steering position sensor
(WP 0009, Figure 197) (WP 0169).
Connect the rear chassis wiring
harness connector FA-C21 (WP 0009,
Figure 124) to transmission ECM J2
(WP 0009, Figure 112).
Proceed to step 2.
2. Using the MSD (WP 0006), select 2201-03 Code Active - Repeat
Implement 120M and verify 2201- troubleshooting code from the
03 is not active.
beginning.
2201-03 Code Not Active -
Troubleshooting complete.
Test Step 8. Test for Shorted Rear
Chassis Wiring Harness.
1. Remove jumper wire between
UC-C2 (WP 0009, Figure 196)
terminal 2 and machine ground.
2. Using a digital multimeter, mea-
Continuity - Proceed to Test Step 9.
sure resistance between rear
No Continuity - Proceed to Test Step
chassis wiring harness connector
12.
FA-C21 (WP 0009, Figure 124)
terminal 16 and all other FA-C21
terminals.
There should be no continuity.
0031-57